Your millage may vary based on the vinyl used and how far out the blade is set, etc. Fun to do this, If I do use it, I’ll have to redo the magnets so they are flush and have direct contact with the screws on the head, and/or re-do the 3d printed parts to provide more support. Still showed signs of torque on the head but since I slowed it down, it was able to stay together. I had to slow it down a lot (5 mm/sec) and had to change the height offset to about 0.25 mm so it would just cut the vinyl I had and not go through the vinyl backing. ![]() I might have glued the magnets a bit too deep into the attachment because the first time I tried to use this, the head get pulled off the rods. I finally found a little time to play with my cutter.
0 Comments
Leave a Reply. |